Capacity
All power take-offs are particularly designed for generating hydraulic pumps to SAE J744C series ‘B’ specification with splined insight shaft and either two-bolt or four-bolt fixing. The maximum power which may be transmitted can be 22 KW (29.5 bhp) per 1000 rev/min engine speed; this compatible a torque of 209 Nm (155 Ibf.ft. – 21.33 kgm.).For PRM1000 the clutched power take-off gives pump rotation the same as the engine, where as the direct drive power 
take-off for the PRM500 and PRM750 gives opposite rotation. Power to the pump isn’t affected by the standard use of the gearbox for propulsion responsibilities. All ancillary power circuits powered by PRM power take-offs should be designed relative to the recommendations of the hydraulic gear manufacturer, and should be correctly safeguarded against overloading.
Installation
PRM power take-off units fit on the trunk face of the primary gearcase and are driven by the input shaft; consequently they could be operated at all times whilst the engine is definitely running, The power take-off replaces the finish cover which is generally fitted and performs the features of the end cover by sealing the gearbox against lack of oil and correctly positions the input shaft rear bearing. Power take-off units also provide the link between the gearbox and the hydraulic pump.
Direct Drive Power Take-Off
Available on the PRM500 and PRM 750 the direct drive power take-off can be driven directly from the gearbox insight shaft; consequently it’ll operate all the time when the engine is operating, and since there is no clutch for disengagement of the hydraulic pump, provision should be manufactured in the auxiliary hydraulics circuits for pressure by-complete to the reservoir when power to the pump is not needed. A set of 1:1 ratio gears, providing enough offset between the gearbox result shaft and the centreline of the energy take-off to make sure there is sufficient clearance between your hydraulic pump and propeller shaft coupling.
Specifications
Ever-Power PTO Shaft
Series 6
1-3/8 inch 6-spline tractor end yoke and a 1-3/8 inch 6-spline FD2 clutch on the implement end
FD2 clutch
Collapsed length: 47 in.
Prolonged length: 60 in.
62 HP at 540 RPM
98 HP at 1000 RPM
FD2 clutch attaches with one bolt that matches a groove on input shaft of rotary mower
Click view independent reviews regarding pto gearbox.